A simple to use comparative viscometer for quality control applications, particularly suited for use in the ceramics industry but can be used with other viscous materials with viscosities up to approximately 10,000cp.
- Simple manual operation - no electrical connections required
- Results can be obtained in minutes
- Can be located on the factory or workshop floor
The instrument comprises a torsion wire attached to a flywheel, suspended above an engraved 360°C scale and a bob for immersing in the sample. Applying a torsion allows the fly-wheel to over- swing. This is a measure of the sample viscosity. Results obtained are usually expressed in over-swing degrees. Overall 150 x 240 x 730mm high. With flywheel, engraved scale and stand. Supplied with one each 30swg wire, 11/16 inch bob, sample cup and instructions.